A roll of hemp rope, a hook needle, and a grid board can make a versatile door pad

Ha ha, everyone, I am Ame!

One roll of hemp rope, a grid board

You can make a simple door pad.

Then take some acrylic pigments,

Both furniture can be matched!

I have a cute little cute watch here!

Materials:

Carpet embroidery grid cloth, 1.8mm crude cotton hemp line, hook needle suitable for rope lines, beautiful workers, cardboard, spray bottle nozzles, propylecase pigments, 4 empty glass bottle, white paper, hair dryer, iron, iron, iron, iron, iron, iron, iron, iron, iron, iron, iron, iron, iron, iron

step 1:

Cut out the size of the grid fabric and start weaving. Use the hook needle to hook the rope line from the grid of the corner to form a ring.

Step 2:

The hook needle extends into the adjacent grid, grab the rope line hook out of the second ring circle

Step 3:

Grasp the second loop from the first ring to get a needle

Step 4:

Continue to grasp the third ring circle from the adjacent grid

Step 5:

Grab the third ring in the previous ring

Step 6:

Repeat the above woven method to make an example along the edge hook until another corner

Step 7:

Exhale the hook needle into the adjacent grid of the corner, grab the weaving line, and continue to weave in the same way 2-5 method of step 2-5

Step 8:

Then turn to and continue the carpet woven in the next circle, continue to hook up according to the line

Step 9:

Until the woven of the entire blanket

Step 10:

Start the edge of weaving the blanket, extend the hook needle into the grid at the edge of the corner, hook out the first ring circle

Step 11:

After a circle around the front end of the hook needle, grab the ring circle from the first ring circle

Step 12:

After hooking the second ring circle from the adjacent grid, the same step 11 is also trapped by the front end of the hook needle.

Step 13:

Opposite the front end of the hook needle again, and grasp the ring in the first two circles through the ring, merge into 1 needle

Step 14:

Continue to hook the edges according to the method of step 11-13

Hook to the corner to continue the weaving of adjacent edges

Step 15:

Complete the woven of the entire carpet, and hide all the thread header

Step 16:

Start making tassels on both sides of the carpet, how long the tassel needs to be, so the cardboard is cut into how wide it, and the rope line is wrapped on the cardboard (as shown in the figure below)

Step 17:

Cut off the edge of one side, so that the tassel line of the same length is obtained

Step 18:

The hook needle extends into the edge short -sided needle, grabs the middle of the flow Soviet line, and draws out the needle

Step 19:

Put on the head of the two ends into the ring and tighten it

Step 20:

Continue to weave the upper-woven Sub-stream by step 18-19

Step 21:

Both sides are woven with the same length, tassel

Step 22:

You can also add colors to the carpet, select 4 colors to harmonize with white tone into the light color system you like

Step 23:

Put the blended pigments into the glass bottle and add water to mix well

Step 24:

Put the spray bottle spray head in the glass equipped with pigment water

Step 25:

Use paper to cover the carpet, leaving only the part that needs to be colorful

Step 26:

Use the spray head to spray the carpet evenly, remove the paper

Step 27:

You can use a hair dryer to speed up the sprayed color area to speed up

Step 28:

The other side is sprayed with another color according to the method of step 25-27

Step 29:

Then spray the carpet with other color blocks in the same way

Copycin pigments must be solided on the surface of the weaving blanket with the help of iron

The carpet after ironing can be easily cleaned without fading

Step 14: