Repair the leakage failure of Collea toilet

Recently, the house is slowly leaking, and I haven’t found it yet. As a result, this month is much higher than before. I found a little bit of investigation. Today will be repaired. Open the water tank and observe carefully.

It is found that this red stopper pose is aging, resulting in a little gap on the side, and the water can’t blocked. Now remove it to handle it, see if you can fix it.

It took a lot of strength, I finally took the water cockroach to remove it. This plunger has been used for more than 10 years, and the contraction is too strong. It is difficult to repair, and the way I can think is to try to make a lap rubber on the side.

Take out a broken bicycle inner tire, cut off. The radiator is appropriate according to the arc of the edge of the plum.

Use gel to bond them together, wait for ten minutes, so that glue is solidified.

After sticking, trimmed it with scissors. This is done in this way.

Get the toilet tank and install back in place.

Check the chain to check it, it looks good. Drain the pipe, it seems to be blocked.

Perform water production test, it is also the same problem, and there is no improvement in slow leakage. Oh, I am busy.

There is no way, I can only go online to purchase a special water plug for a Kohle toilet. Selling this kind of commodity store is very small, and after the order is over, I have been waiting for a week. I finally received the delivery.

After disassembling the package, the new and old pliers were put together. It was found that the old plose was really a full circle than the new time. It turns out that rubber aging shrinks so powerful! It’s amazing.

In exchange, the water leakage problem of the toilet is completely solved. It’s completely not missing, this can be used for more than ten years, it is great! The toilet is also happy to show smile.