What to do if the washing machine drainage valve is broken and the solution is caused

What to do if the washing machine drainage valve is broken and the solution is caused

The washing machine is a common home appliance for our daily homes.

What should I do if the washing machine drainage valve is broken

Tell everyone the cause and solution of the faulty valve of the washing machine drainage valve. I hope to be helpful.

1. There are miscellaneous objects in the drainage port, water pipe or valve

[Causes of faults] The most common reasons for the drainage outlet, water pipe or valve are not drained. When cleaning clothes, there may be paper, plush, coins, etc. in the pocket or clothes. Young objects may enter the drain valve to affect the drainage of washing machines.

[Solution] If the miscellaneous drainage or drainage valve is at the washing machine, the washing machine can be turned down. Open the drain valve spring clip of the washing machine and remove the drainage pipe to clean the debris. If the drainage is not very smooth after cleaning the debris, it is recommended to raise the other end of the washing machine to make it easier for sewage to clean up as soon as possible.

2. Drainage valve wire rope loose

[Causes of failure] If the water drainage operation is used frequently, the wire rope connected to the drain and drain valve may be loose. When the drainage valve switch is turned on, the drain valve cannot work normally, affecting the drainage effect. If the wire rope is broken or derailed, the drainage work cannot continue.

[Solution] Disassemble the shell of the washing machine, replace the wire rope, or tighten the wire rope, but don’t be too tight, all the leakage of the laundry will occur.

3. Destroyer traction device is damaged

[Reasons for failure] If the washing machine has an abnormally sound during drainage, and the drainage effect is not obvious, there may be a fault in the drain valve traction device.

[Solution] Open the back cover of the washing machine and check the drain valve traction. If it is really a problem with the tractioner, it is recommended to replace it. If you can’t solve it, you need to ask professionals to repairs and replace it.

The working principle of the washing machine drainage valve

The washing machine drainage system is controlled by an independent motor. The structure of the drainage valve is similar to that of the pheasant. Inside, a leather bowl is promoted with a plastic rod. When the motor is in situ, the leather bowl blocks the outlet. During drainage, the circuit board is also started by controlling the motor by a MOS tube. When the motor rotates, the plastic rod is pulled backwards through a steel wire, so that the leather bowl is separated from the drainage port, and the sewage will be automatically discharged. When the solenoid valve acts, the AC voltage and the coil are connected to form the electromagnetic field. The drain valve automatically opens the valve, and the water in the washing machine can be excluded directly from the valve. When the AC voltage is broken, the electromagnetic field disappears, the drain valve stops working, the valve is automatically closed, and the water in the washing machine cannot be removed.

How to disassemble the washing machine drainage valve

1. Use pliers to remove the opening of the connection between the solenoid valve and the adjustment rack.

2. Remove the chassis connection screw and remove the spillover pipe and drainage pipe.

3. Hold the valve body to rotate several times to separate the drain valve from the drainage port of the bucket.

What should I do if the washing machine drainage valve is broken

Product Recommendation: 1/2 drain valve

You may also like...

Popular Posts